Living the Home Spa Life

1-800-770-0292 · 8am-5pm PT M-F

1. Anonymous
   Unregistered

   I have a Jacuzzi 220 and after a recent draining and cleaning the fill and start
   I got a FL-2 for 30 seconds then every thing was went to normal on the digtal pad.
   Everything works, pump, heater, light but 2sets of the four jets don't work.
   Re-checked every thing but still does not work.
   Please advise.
   Thanks

   Posted 4 months ago #

2. Mary
   Moderator

   Since you got a flow error code when you first started up you may have had an air lock in the pump since it was drained and refilled. You can try running the pump and just slightly unscrew the drain plug on the pump just enough to allow a small amount of water to drain out.
   Also check and make sure diverter valves are open. Depending on the year of the spa some jets can be turned off by rotating the face of the jets, verify that they are open if that is the case.

   Posted 4 months ago #

RSS feed for this topic

Reply

You must log in to post.