HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 2 of 2
Thread: Spa Jets
09-10-2012, 07:49 AM #1
I use my spa only during the summer months, May to September. I winterize the tub the remaining months. Recently I have had a few problems with the jet covers coming off the tub. These jet covers are the Waterway 3 3/8" textured face covers. I noted that the plastic clips, there are 2 on each face cover have become brittle and snapped off. My question - is this just normal aging of the jet covers and I can expect all of the jet face plates doing the same thing? I have ordered replacement covers from Hot Tub Works. What is the correct method to install the replacement face covers on these jet face plates. The repacement part # is Waterway - 2-212-8017 if that helps.
Thanks for reading.
09-10-2012, 07:53 AM #2
I have seen these become brittle over time. Waterway has improved the plastic and replacements should last quite some time.
All times are GMT -7. The time now is 12:29 PM.