HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Voltage reading on circuit board
Results 1 to 2 of 2
Thread: Voltage reading on circuit board
08-29-2012, 10:58 AM #1
I have a prr error code on my panel which suggest the temerature regulation probe. If I disconnect the probe at the circuit board and put a volt meter on each of the 4 legs on the board where the connector block goes; should I expect a reading? I've tried and have nothing, does this suggest the circuit board needs replacing?
very many thanks for help
08-29-2012, 11:05 AM #2
You probably wont get a reading there. Usually when you get an error code like this it is best to replace the sensor.
All times are GMT -7. The time now is 01:29 AM.