HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 11 to 14 of 14
Thread: Temp probe problem prr
09-20-2012, 06:54 AM #11
I thought it was a temp sensor fault, thats what I've read everywhere else on the net
09-20-2012, 07:09 AM #12
Yes you are correct, my mistake. PRR in Gecko and HydroQuip packs means temp sensor alarm or failure.
09-24-2012, 09:16 AM #13
As of yet I have not wired the temp sensor up to the cable and it is still sitting wedged into the circuit board, the prr code has gone , but I wouldn't reccomend this as it only reads the ambient temp under the tub as opposed to the water temp and your water will just heat up until the HL switch kicks in.
My plan is to solder the new temp sensor onto the existing cable and put into the existing metal tube. First you will need to drill out all the old potting compound and cables, then slide your new sensor into the tube with some potting compound sourced from ebay again (about £5). as you have the exisiting plug on the cable it should work...I emphasize should as I've not tried it yet but at least it got rid of the prr code. get some advice from an electrical geek before trying. I'll let you know how I get on when I try it, better to spend £6 at trying to fix it than sourcing a part for £70 that doesn't even fit!
10-03-2012, 12:46 PM #14
That's great thx for that jimbob let me kow how you get on please and I'll do the same
All times are GMT -7. The time now is 07:27 AM.