HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- 1 Jet/air Issues - Leisure Bay Smart Series LB102 Spa
Results 1 to 3 of 3
08-04-2012, 12:50 PM #1
New to this forum and new to having a hot tub but .... I Recently purchased a used Leisure Bay Smart Series LB102 spa about ten years old. One problem with it was the GFI 115v plug was defective, hacked it off and wired it straight to an outlet on a 20A GFI Breaker.
I am now finding that the largest jet does not work for your lower back on the lay down side of the tub, I have tried twisting it etc to see if you could manually turn it on/off with no success. I removed the panel and can see the water is flowing slowly in reverse by looking at the clear tubing attached to it. Any Ideas as to what could be wrong with this one jet since obviously the pump is running correctly?
Now when it comes to the Turbo Air vents I have 2 of the 12 not pumping air and also feel to be pulling slightly instead of pushing which again is strange considering the rest work fine.
Any help or suggestions appreciated. I have purged the air vent at the filter housing many times as well with no luck.
02-26-2013, 10:03 AM #2
I am having the same issue, can't get jets to work on one side. Altho, I see no water flowing when I take off the dial.
02-26-2013, 10:15 AM #3
I am not familiar with this model spa the way it is plumbed. When turning the air control up on top of spa, probably closest one to the jet it doesn't make a difference? It may be a bad air control not allow the air to mix with the jet when you open it. On the first post with two air injectors not working but others do that is strange, usually manufactures with have them plumbed together using an air manifold. Maybe there is debris in them clogging those two up.
Tags for this Thread
All times are GMT -7. The time now is 12:23 AM.