HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen Adult Porn sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- 2000 Sundance Palermo problem
Results 1 to 7 of 7
Thread: 2000 Sundance Palermo problem
07-19-2012, 01:18 PM #1
Hello. I have been noticing my hot tub control panel has been throwing out some crazy characters lately. A breaker reset has fixed this problem, until the other day i got the FL1 error. I drained the tub and refilled, left the filter out and still get FL1. The "two speed" motor will only work on high speed. I switched the wires on the circuit board(putting the low on the high terminal, and the high speed on the low terminal)and the motor then worked on low speed with the control panel thinking it was on high. I changed the presure switch too. I hear a clik when it tried to cycle on low but i get no motor. It's a 2hp waterway pump with one capacitor. Can i safely say the motor and cap are good? Thank you in advance for any help!!!
All times are GMT -7. The time now is 11:17 PM.