HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen Adult Porn sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- DreamMaker Odessey Questions
Results 1 to 2 of 2
Thread: DreamMaker Odessey Questions
03-05-2012, 01:07 PM #1
I'm new here and hoping someone would be able to point me in the right direction.
I have found a DreamMaker Spa that a my dad's friend is willing to take 50 bucks for to get it out of his way. He says the only problem is that it doesn't heat up anymore, but the pump circulates like it's supposed to and everything else works. I've done some research and noticed that DreamMakers do not have a separate heater, but rather heat the water with the pump itself. Would it be possible to install a heater in the plumbing of the tub after the pump, possibly one that would have it's own thermostat? The tub is ran off of 120v, if it's possible to add in a heater, I would like to run separate 240v to the heater and have the heater turned on by the stock controls via a relay. Is this possible?
03-06-2012, 07:10 AM #2
If you want to go that route I would suggest a whole new controller. It comes with the control box with circuit board, heater, and new topside panel. You could still use your existing pump or pumps.
All times are GMT -7. The time now is 09:09 AM.