HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Balboa 2000LE HS200 M7 Problem
Results 1 to 3 of 3
Thread: Balboa 2000LE HS200 M7 Problem
09-03-2011, 03:23 PM #1
My Platinum II spa has a Balboa 2000LE HS200 M7 control system with a standard digital panel. Pump # 2 wasn't working, and I found the run capictor went bad. After I replaced it, the pump ran with no problem. After a few days, my controller did not function properly. When I power the spa down and up again, it goes through all the correct functions: it primes for 3 minutes,the blower comes on for a minute, pumps 1 and 2 come on and operate for 5 minutes. Once startup is complete, the following occurs: Pressing either raise or lower temp causes the set point to go up; the light button - turns pump #2 on and off; the blower button turns pump #1 on and off, Jet #1 works correctly and jet #2 works correctly; the Mode button does nothing. Has anyone experienced something similiar? I suspect the digital panel, but don't have a way to check it out.
09-06-2011, 07:42 AM #2
It does sound like your topside panel is malfunctioning. Does the pump come on normally for a filter cycle or heat call? If so it is more than likely the topside causing the problem.
09-06-2011, 09:24 AM #3
The controller is in the Econ mode When I push the mode button, the mode doesn't change. I haven't been at the spa to see if the pumps come on during a filtering cycle but the temperature is being maintained at the set point. I also cannot check what the filtering cycle is set at because the control buttons don't do what they are supposed to do.
All times are GMT -7. The time now is 08:17 PM.