HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Newbie with a rebuild project.
Results 1 to 2 of 2
Thread: Newbie with a rebuild project.
06-07-2011, 02:41 PM #1
I'm taking on the task of rebuilding a 4 person spa. The old pack/pump is beyond repair and I'm replacing the jets do to age and cracking. I have a parts list for jets and jet bodies but I'm stumped on how to size the right pack and if I need an air blower. The tub looks like it might have had one at one time to blow bubbles up through the edge of the seats. There were three air control devices that are being replaced as well that supply air to the jets.
I have no idea who makes the tub but its big, 91" square. Is there any tell tail marking I can look for or does it even matter at this point?
This will eventually be an in-deck install.
So if anyone can recommend a pack or sizing chart or any other info, I would appreciate it.
Website recommendations for parts or packs would be great. That way I can compare prices of the items I have on my workup list.
06-08-2011, 10:37 AM #2
It sounds like you may have air injectors in the seats, that is where they normally are installed, then you would need a blower. Usually the rule on horsepower on the pump is for every 6-7 main therapy jets is how many horsepower. So if your spa has say 15 jets you may want to go with a 2.5 hp pump. We have a variety of different control systems to choose from. If space is a factor in the equipment area of the spa you may want to consider a Flex Fit Digital pack. If not then one of our Balboa or Standard Digital packs should work just fine. If your spa only has one pump and a blower then the Balboa VS501 system would work great, or if two pumps and a blower the Balboa VS510 would be a good choice.
All times are GMT -7. The time now is 01:45 PM.