HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 2 of 2
Thread: Aqua-flow bearing/seal question
01-12-2014, 08:07 PM #1
I'm rebuilding an aqua-flow pump from my Morgan hot tub.
The seal is cracking and hard, very difficult to remove. A part of the seal is stuck in the wet end (rear). I cannot remove the rear wet end until this seal is removed first. Any ideas?
This bearing has grease all over it, and it appears burned. Does this indicate it is bad?
Lastly, I was using a rubber strap wrench to remove the impeller, and it cracked a chuck out of the impeller. Is this impeller still usable?
Thanks for the help!!!
01-15-2014, 07:41 AM #2
If you still cannot remove it you may want to take to a motor shop, they usually will help you remove the wet end. You will need to replace the impeller for it to work properly.
All times are GMT -7. The time now is 01:14 PM.