HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- blinking heater light...pump and heater off
Results 1 to 2 of 2
07-27-2010, 01:32 AM #1
I have an old jacuzzi hot tub about 13+ years old. The control panel is 1 knob and 1 cycle button with 1 light that indicates the heater is on. I've noticed the last few years if the pump runs on high for about 30+ minutes, the pump, heater and light shut off and the heater light blinks. After about 30-60 minutes, the blinking stops and all will work again. Some times it will fail on low if the pump runs for a while. I'm thinking the pump is ready to be changed out. What do you think?
07-27-2010, 05:39 PM #2
It sounds like the spa pump may be thermally cutting out. I believe this because when the pump quits the spa heater is shut down and heat indicator starts blinking. That is a flow code, meaning system thinks pump should be on but there is not water flow going through so shuts down. You can take a voltage reading going to pump when it quits to verify. If you have voltage then pump/motor is probably going out. You can also remove the pump and make sure the impeller turns freely and is not binding up causing the motor to overheat.
All times are GMT -7. The time now is 02:13 AM.