HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen Adult Porn sizlerle onerimizdir.
Results 1 to 2 of 2
05-27-2010, 01:06 AM #1
My spa pack is throwing a PSoL error. I can turn it to high, and lots of water comes through, but when I turn it to low, it immediately changes to PSoL and doesn't heat.
1) I loosened and retightened the ring around the top (outflow) of the pump until no air comes out (just water). Now, it only squirts out water when I loosen this ring.
2) I let it run for a quite a while on high.
3) I replaced the filter.
Then we removed the spa pack. Water flows great out of both of the cut off valves that go to the tub, and water flows through the filter OK. The inside of the spa pack where the heater coils are is still shiny. There are no visible obstructions in any of the pipes around the spa pack.
We did have a hard freeze last winter. I had drained the water on the tub, but the big plastic ring on the filter had cracked. Now I am wondering if the pump cracked.
Since the flow seems to be OK, is there a way to over-ride the PSoL error? Is there something else I can test?
05-27-2010, 05:30 PM #2
When pump is in low speed is there water coming out of the jets normally? I know you said it does on high speed. If water is coming out like normal in low speed it may be a bad pressure switch. You said the filter is new but have you tried removing it to see if the PSoL goes away? There is no way to over ride this error code, it could cause a problem if the flow is too low and the heater is allowed to come on.
All times are GMT -7. The time now is 10:41 PM.