HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- o-ring lube and installation?
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 2 of 2
Thread: o-ring lube and installation?
05-20-2010, 08:48 PM #1
I'm replacing the 2 inch o-rings and split nut union on my Balboa heater. The O-ring is rubber and the split nut union holds together a metal pipe (on the Balboa unit) and a PVC pipe.
What kind of lubricant is safe to use on the rubber o-ring, metal, and PVC? I know Vaseline deteriorates rubber. Would a silocone lube be ok, or can I used cooking oil/Crisco, OR do I need to go buy some Plumbers Grease? I have heard that the o-ring lube is a rip off and I don't need it. I've read all different answers to similar questions on the plumbing forums.
I don't want to use anything that will deteriorate the rubber o-ring faster than they normally deteriorate on their own. They are a pain to replace, not because putting in an o-ring is difficult, but because these particular o-rings that I have must be ordered on-line and take several days to be shipped (only one site sells them, too.)
One other question: if water is trickling out of the Balboa metal housing, can I put the o-ring on, or should I want until both ends are dry, lube them up and then attach them? My boyfriend and I disagree on the answer to this, so...can't wait to hear what you have to say!
Thanks in advance for all responses!
05-21-2010, 04:46 PM #2
They don't need to be dry to replace. I would recommend using a silicone lubricant. I wouldn't recommend any of the other products that you listed.
All times are GMT -7. The time now is 05:38 PM.