HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen Adult Porn sizlerle onerimizdir.
Results 1 to 3 of 3
Thread: No heat
04-02-2010, 07:31 PM #1
I've replaced the heating element and the temperature pressure switch and can only get water up to 77 degrees. Before I swapped out my old temp pressure switch I screwed the top adjustment screw all of the way down and the temp went up to 99. Now after swapping it for a new one the water only heats to 77. Any thoughts?
04-06-2010, 04:32 PM #2
Does the heat indicator light or symbol come on when you turn the thermostat up for a heat call? Have you tried removing the spa filter to see if the heater comes on? Usually pressure switches are factory set and don't need adjusted. It could be a bad thermostat, or relay on the circuit board causing this as well. That is why I need to know if the indicator comes on in a heat call.
09-04-2010, 11:54 PM #3
I have basically the same problem and have no heat indicator light on. Removing the spa filter does not make a difference in this situation. Can you help?
All times are GMT -7. The time now is 08:48 AM.