HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen Adult Porn sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- 'SL' > Spa went to sleep...died. whatever.
Results 1 to 3 of 3
02-06-2010, 11:31 PM #1
Well, in that this NEW Balboa spa pack came with no manual and none is available at either Hottubworks or Balboa Instruments, I'm rather distressed. I have Tub getting colder and colder in freezing weather in a snowstorm. The balboa instruments site says that the unit is in 'sleep mode', and to just change it back to normal...without a manual it's rather difficult. I myself never put it into sleep mode and didn't even know there was one. The actual temp is now in the 60's(F) and with both companies asleep for the weekend I can see it's going to be a race to see if I can get an answer before the tub has to be emptied to avoid a rupture. I've tried cutting power to enable a reboot to no avail. Suggestions?
02-08-2010, 06:29 PM #2
The operation card should have been included. By pressing the "temp" or "set" button and then light that will allow you to change modes. I have asked you to email directly and I will email you back a copy of the card. We are very sorry for the inconvience.
12-13-2011, 06:34 PM #3
Ya seems like that should work just fine Great "customer service" though
Last edited by Amy40; 12-26-2011 at 10:57 PM. Reason: addition
All times are GMT -7. The time now is 06:12 PM.