HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 3 of 3
Thread: Tripping breaker!!
01-19-2010, 06:21 AM #1
I've had a Sun Valley Spa for a few years now and it worked fine until it went out of warranty. Since then it has been a nightmare to deal with. The company I purchased it from just wants me to pay them. I used to be an electrical engineer and used a professional electrician to wire the spa. We did it by the book just like the place I bought it from recommended. Recently, I took the circuit board pack to the company to have tested because it was always blowing my breaker to the point it wouldn't reset. They tested it and said it was fine and charged me $100. Took it home and had my electrician test everything else. It was fine as well. Took it back to them and they said I need a new circuit board. So they order a board and then my tub started working on its own. Then it again quit and I took it back to them and talked them into looking at it at no charge. They said I needed a new heating element. That was $80+. Installed that and it worked for about 2 weeks and then started tripping the breaker again. Any idea what is causing this? Granted it doesn't do it as often as it was, but it is still several times a week. I am a firefighter so I am not home everyday to check the breaker and with it being the dead of winter here in Missouri I don't want to run the risk of the breaker blowing and me not being around to reset it to keep the water heated to where it won't freeze everything up. I haven't even been able to sit in it so I know it's not from water splashing down the side into the spa pack. Plus, I sealed the topside panel so it wouldn't leak even if it gets wet. Sorry for the long rant, but I'm getting tired of throwing money at this thing for it to just sit there.
01-19-2010, 07:17 PM #2
Usually if the spa is causing the GFCI breaker to trip and not the breaker or wiring it is usually one of the following components that will cause it to trip. Your heater, one of the pumps if you have multiple, the blower, ozone, or circulation pump. Since this is an intermittal problem it is going to be more difficult to pinpoint the cause. Can you get it to trip by turning on your pump and put the spa in a heat call? For the most part to determine which component is causing the problem you need to do a process of elimination. You would need to disconnect one component at a time until the breaker holds. This may be difficult since it doesn't trip immediately and it's cold out.
01-19-2010, 11:06 PM #3
That's how we figured out the heating element was bad. However, last night I tried to turn on the jets after I got the breaker back on and all I got was the clicking noise. I'm on duty for the next two days so it'll be Thursday before I can get the chance to troubleshoot.
All times are GMT -7. The time now is 07:20 AM.