HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 2 of 2
Thread: Cal Spa "Sn" display
09-18-2009, 10:38 PM #1
My Cal Spa will not start (possibly following a close lighting strike) I get a "Sn" display reading but tub will not turn on. Any suggested diagnostics I can do?
09-22-2009, 07:38 PM #2
You can try unplugging the spa sensor harness, wait a few moments and then plug back in. You would want to turn the power off before doing this. Usually a SN error code is signaling that one of the sensors is failing, but since you said that it was a possible lighting strike then your circuit board could have been damaged.
All times are GMT -7. The time now is 11:21 AM.