HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 2 of 2
Thread: impeller removal
08-30-2009, 09:34 PM #1
I am looking for information on removing an impeller form my pump motor. I need to replace the seal and slinger. My question is is the impeller a rt or lt hand thread and does anyone have any tricks for getting it off. I have tried having someone hold a large screwdriver at the one end and using a socket on the impeller formed acorn nut but have been unable to remove it. I don't want to have to destroy it and buy a new one.
Thanks for any help
09-02-2009, 05:19 PM #2
Spa pumps will normally have a right hand thread. So when you remove the back plate on the motor and use a screw driver in the slot you would want to turn the screwdriver to the left and the impeller in the opposite direction. Unfortunately it is not uncommon to break a impeller when trying to remove. You can get rust built up on the shaft and will freeze the impeller onto it.
All times are GMT -7. The time now is 08:05 PM.