HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Balboa VS - M7 System not heating!
Results 1 to 2 of 2
10-03-2013, 05:39 PM #1
Hey All! My tub isn't heating! The topside panel seems to be displaying the temperature accurately and there are no error codes.
I checked the heater using my multimeter and it was right around 12 Ohms so that seems fine. I then checked the copper leads coming off of the board while I had the topside panel set to HEAT and there was no power...
Should I just order two new M7 Sensors? That's what I was planning on doing (hoping it isn't the board)
Let me know if you think otherwise. Thanks all!!
All times are GMT -7. The time now is 11:00 AM.