HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen Adult Porn sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Balboa VS - M7 System not heating!
Results 1 to 2 of 2
10-03-2013, 05:39 PM #1
Hey All! My tub isn't heating! The topside panel seems to be displaying the temperature accurately and there are no error codes.
I checked the heater using my multimeter and it was right around 12 Ohms so that seems fine. I then checked the copper leads coming off of the board while I had the topside panel set to HEAT and there was no power...
Should I just order two new M7 Sensors? That's what I was planning on doing (hoping it isn't the board)
Let me know if you think otherwise. Thanks all!!
10-04-2013, 08:29 AM #2
If the heat light is showing on then the sensors are doing their job and sounds like there is an issue with the circuit board. If the heat light is not coming on then I would be looking at the sensors as the issue if you have good water flow and no error codes. Also if the heat light is not coming on try removing the filter and run it to see if it comes on.
All times are GMT -7. The time now is 10:12 PM.