HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 2 of 2
07-03-2009, 04:17 PM #1
I just replaced my pump and onzonator and the tub is not heating up (after some time the breaker trips off). I can hear the click after i put the spa on and i have check the leads that are on top of the heater housing. There is electric at that point. What else can i check can anyone help me.
07-06-2009, 02:51 PM #2
The error code 32 on Gecko controls indicates that the temperature sensor is not being detected or is bad and needs to be replaced. However the temp sensor would not cause the breaker to trip. You would need to determine which component is causing the breaker to trip. Usually heaters, blowers, ozones, and pumps would cause the breaker to trip. I would start by eliminating one component at a time by disconnecting the heater first and let the spa run to see if the breaker trips.
All times are GMT -7. The time now is 09:59 AM.