HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- help replacing jet assembly
Results 1 to 2 of 2
Thread: help replacing jet assembly
06-13-2009, 01:54 AM #1
I have a 1999 dimension one diplomat spa. I need to replace a jet assembly which has a hole at the elbow where it connects to the pvc tubing. What is the process for removing the old one and installing a new jet assembly. It is one of the larger 4 inch jets at the top. Thank you!
06-16-2009, 06:26 PM #2
Depending on the style of jet they used there will either be a large nut on the back side of the jet that would need to be removed in order to get the jet wall fitting out. Some jets however thread into the jet back from inside the spa. This would require a tool to remove. After the jet face has been removed there would be two holes or knotches that the tool could be inserted in to unthread the jet face from the jet back.
All times are GMT -7. The time now is 04:28 AM.