HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 5 of 5
Thread: Heater wont work
06-02-2009, 01:50 AM #1
I had a SN3 error, so I replaced the two sensors as a unit. When I refilled and powered up it heated up to temp just fine but now the heater will not com on.
I do not get a red heat on light. The jets are working just fine.
This is a 1996 Dimention One
06-02-2009, 08:21 PM #2
Then you are not getting a call for heat if the indicator is not coming on. You may want to remove the filter and put it in a heat call to see if the indicator comes on. This is done to see if you are have a water flow issue preventing the heater from coming on.
06-03-2009, 02:59 AM #3
It turned out to be the Ozone. One of the air tube got kinked. When I straightened it out the Ozone and the heater came on!
06-04-2009, 05:32 AM #4
Now I have an SN3 error again... what else could this be?
06-09-2009, 05:36 PM #5
Typically SN3 is a sign for a malfunctioning temperature sensor. You may want to double check the connection of the sensor.
All times are GMT -7. The time now is 01:01 AM.