HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Jets won't mix air w/ water
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 1 of 1
Thread: Jets won't mix air w/ water
05-19-2009, 08:48 PM #1
I have an older tub with 4 jets and 2 air intakes.
The intakes have screws tops which I open to allow air
Problem is only 2 of the jets will pull air in to mix with the water
It has nothing to do with the pump as the side that works does so with either low or high speed
It's not the jets, because I have swapped them and it makes no difference
I can put my finger on the jets that don't blow air and the water will shoot out of the intake, which makes me think there is no blockage
I can also run a small tube down into the intake and I can't find any blockage
Right now, I'm in the process of replacing the wood around the outside, so I have access to the plumbing
Any ideas on how to get the air going again ?
All times are GMT -7. The time now is 05:25 PM.