HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 5 of 5
05-13-2009, 06:09 PM #1
Our Tiger River tub has a leak; what is the best way to troubleshoot this when the leak is not in front by the pump; it appears to be coming from the side of the tub; when we drain the tub below the jets, the leak stops.
05-18-2009, 05:36 PM #2
I'm having a similar issue with my Hotspring Spa, Any help would be appreciated.
05-19-2009, 06:41 PM #3
This could actually be a jet, air line to the jet, manifold, or fitting. The side panel needs to be removed and the foam exposed. Sometimes you can see the saturated area but not always. By using a wooden dow rod you can probe the foam to find where the moisture is coming from. Once you find this you would need to remove the foamed area to expose the leak. Once the leak is repaired you can fill the foam by using a spray foam kit. http://www.hottubworks.com/cgi-bin/c...n&key=2-P10600
05-31-2009, 03:37 AM #4
How do I go about removing panels from a Hot Springs Jetsetter. I have a leak like the ones posted above, and I need to check inside. Thanks!
06-02-2009, 08:14 PM #5
There should be staples on each end holding the panels in place. You need to use the end of a claw hammer or something similar to pry them up with.
All times are GMT -7. The time now is 03:34 PM.