HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Balboa Vs501Z Dr error code, replaced M7 sensors, good flow, now what?
Results 11 to 15 of 15
08-21-2013, 10:35 AM #11
then you can leave number 3 off if the rectangle panel.
08-21-2013, 10:36 AM #12
If this doesn't clear it DY then I would look into the pump.
08-21-2013, 11:41 AM #13
Took apart and inspected impeller closely, all fins look perfect, started up pump, runs perfectly smooth and quiet. So, is there a way to check if I was sold the correct M7 sensors by the local spa store. They took the sensors off a heater assembly, but the odds seem so slim the exact same error message would come up. No partn number on sensor, just a serial number.S/N 30382***1005130428.
The same place sold me the heater element which cured the original GFI breaker tripping. Thnaks so much for your help and time!
08-21-2013, 11:49 AM #14
That is the correct sensor, what you can try is switching the two sensor at the circuit board, plug A into B and B into the A position on the board. Sometimes by switching them it will work.
08-21-2013, 01:22 PM #15
Nothing works. Any suggestions? I am really stumped!
All times are GMT -7. The time now is 09:02 PM.