HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 1 of 1
Thread: Check Valve Replacement
08-14-2013, 12:29 PM #1
I have a Sundance 1998 Cameo. Recently, the two speed pump stopped circulating water. On inspection, I found what I think to be a faulty check valve located immediately under the diverter valve for the whirlpool/intelli-jets.
I found a small (1.5 inch?) in diameter disk with rubber on the edges free floating in the check valve. I'm guessing it was once attached and broke free. In the position I first found it, it was blocking circulation. When I flipped it upside down, all but one jet works fine. I think this disk is larger than the hole for the diverter valve, and in any event, it is not possible to grab with anything I own. (It's about 14" down below the diverter valve surface.
What is this check valve for? Do I need to replace it if everything seems to be working well (except for one seat we never use)? Is there any harm in just leaving the detached part there?
Tags for this Thread
All times are GMT -7. The time now is 01:13 AM.