HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 2 of 2
07-15-2013, 07:49 AM #1
I have a j-340 240 volt tub.
The circulation pump is running, the heater light is on but the heater will not work. So far here is what I have.
The heater input at the board measure 230 volts ( across both terminals)
The heater output measures 30 volts ( across both terminals).
Unplug the heater output terminals and measured at the circuit board spades 30 volts.
The heater element reads 0.50 ohms on a 20k setting on meter.
Circuit board terminal for the heater output has a small amount of black smoke on then connection..
Looking for some advice ...
Thank you ..
07-15-2013, 09:48 AM #2
You should be getting 220V on the heater output across both leads when the heater indicator light it on. Also, the heater element when test ohms should be around 9-12 on a 5.5kW element.
All times are GMT -7. The time now is 05:56 AM.