HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Sundance Del Sol motor replacement
Results 1 to 4 of 4
04-20-2013, 03:46 PM #1
I need to replace the motor on a 10-12 year old Del Sol. The motor sits behind the electrical box, so it appears that the electrical box needs to be moved to gain access to the motor. However, the box is attached to a stainless steel tube directly behind it. I think the tube is part of the air system, and could be disconnected, but not sure.
Thanks... Dave H... Los Angeles
04-22-2013, 12:14 PM #2
The tube may be the heater. Sometimes you do have to remove components just to get to another one. Have you tried removing the side panel to see if you can get access that way?
05-07-2013, 05:41 PM #3
Thanks Mary.. Yes, the tube is the heater. I got the motor out of the spa by disconnecting heater and moving the control box aside. I think the motor is OK, but am now having trouble pulling the wet end. I pulled the outer case, but can't get the impeller off. It's an ongoing adventure dh
05-07-2013, 06:16 PM #4
Most impellers will thread onto the motor shaft. It is not uncommon for the impeller to be super tight on the shaft so sometimes they will break when trying to remove it.
All times are GMT -7. The time now is 10:33 PM.