HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- 1990 jettsetter temperature control/copper?
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 2 of 2
03-28-2013, 10:01 PM #1
Greetings. My '90 jettsetter either is too hot or too cold. The copper wires are a bit chaotic and may be in the wrong place. I have one probe that inserts into a hole in the bottom of the wood frame of the compartment. Is there also supposed to be a probe going into the center of the heater?
Any help is appreciated!
03-29-2013, 08:09 AM #2
There should be another copper bulb that inserts in a thermowell on the heater too.
All times are GMT -7. The time now is 01:46 PM.