HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Hydroquip controler keeps popping circuit breakers.
Results 1 to 2 of 2
03-28-2013, 04:51 PM #1
My hot tub keeps popping curcuit breakers after opening it up for summer use. I have hydroquip controls. when I opened the panel it had alot of moisture inside. I dried it out the best I could but it still pops curcuit breakers. I unplugged all connections to the controller but no help. can I save this controller or is it time for a new one
03-29-2013, 08:14 AM #2
When you disconnect everything make sure you are disconnecting both power leads to the heater and then run the pump to see if it still trips. Most of the time heaters will cause the GFCI to trip. Make sure it is completely dry inside the controller too. It still may be saved.
All times are GMT -7. The time now is 05:31 AM.