HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full Porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 7 of 7
Thread: jacuzzi j-360
02-20-2013, 02:34 PM #1
I have a jacuzzi j360 had the flow regulator replace on it and since then it says its over heating and water is no where near the temp it reads, i shut it off and back on and all is fine for a few days. and jets 2 come on when i first turn power on and during cycles but does not respond to the control panel button to turn on after the cycle ends.
02-20-2013, 02:49 PM #2
If the display is reading a higher temperature than the actual water it is probably the temperature sensor causing this, part 6600-167. That is the sensor that displays the water temperature on the topside panel and usually will be the cause. If it goes into OH after it cycles then you wouldn't be able to activate the button on topside until the OH has been cleared.
02-21-2013, 09:37 AM #3
Wont even allow us to use the jets even when its not reading oh. Right now have it turned down to 96 and is holding and reading ok but still not being able to turn on jets 2 with button.
02-21-2013, 09:54 AM #4
ok, I wasn't clear on that. When you push the jets button does the indicator light come on the topside panel? If not you probably have an issue with the topside panel. This is probably a separate issue than the temperature readout not matching actual water temperature. Does your spa have a small remote topside panel other than the main topside, if so try disconnecting that first and then see if the main topside jet button will function.
02-21-2013, 10:21 AM #5
No other control panels besides the main top side one. When you hit the button for jet 2 the display icon does not come on or nothing. All other buttons working fine. Tried and unplugged dispute and plugged it back in and. Still no action from jet 2 button.
02-21-2013, 10:39 AM #6
02-21-2013, 10:32 AM #7
Well unfortunately if the indicator is not coming on when you push the button the topside panel is not working. It sounds like the pump may be coming on during a heat or filter cycle if maintaining heat, just the topside jets button is not working.
Tags for this Thread
All times are GMT -7. The time now is 04:20 PM.