HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
- Everything For Hot Tubs & Spas
- Spa Parts, Repair and Troubleshooting
- Sundance Altamar Not Functioning - Stuck in LOC
Turk videolari arasinda en erotik sahnelerin bulundugu donmadan Full porno izle adresi olarak bilinen xporno sizlerle onerimizdir.
Results 1 to 2 of 2
12-12-2012, 05:17 PM #1
My spa was working fine, then I had an electrical problem, so there was no power available for about 2 weeks. When I did get the power going again, the top LCD panel came back on and is locked and I am not able to unlock it. The display reads out 'COOL' or 'ICE' and the icon of pump 1 is on, but there is no action. Sometimes it gives the numbers of 15: 5 when trying to use the display. I have tried shutting down power for a couple of hours.. but still the same problem. I have tried emptying some water out and then running hot water in to try and warm it up, but still the same thing. Does anyone know if there Is maybe a reset button on the control box? How would I know if it needed a new fuse? Not sure what to do as it is winter... and if I cant figure this out I will be emptying it out this weekend to shut down for the winter. So any help/suggestions would be greatly appreciated.
12-13-2012, 06:47 AM #2
There isn't a reset button on this spa. This may be a circuit board issue or topside panel, but you can't really test the topside without plugging a new one in. When the icon is on for the pump you need to verify that the pump motor is getting voltage. If it is I would replace the pump. When trying to unlock the topside panel are you pushing the display button, then mode, then the down button within 3 seconds? You may want to call for service, they will have tesing plugs and should have a spare topside to plug in to test.
All times are GMT -7. The time now is 01:45 PM.