HotTubWorks Spa Repair Forums
Welcome to the HotTubWorks Spa Repair Forums.
Results 1 to 3 of 3
Thread: Cal spa 5000
11-15-2012, 07:24 AM #1
when you move the temp up to over 100 it trips the breaker and shows a sf (safety function) any help?
11-15-2012, 07:44 AM #2
First make sure power is off to spa and then disconnect both power leads going to heater. Then turn it back on and try to run your pump to see if the breaker still trips and to see if you are still getting the SF code.
12-03-2012, 07:44 AM #3
no it works fine when you do that and this morning it says oh and it's not overheating the temp still says 99 cause i left it there.....any help?
Last edited by swilloug; 12-03-2012 at 09:56 AM.
All times are GMT -7. The time now is 09:04 PM.