http://www.hottubworks.com/spa-repair-forum/ HotTubWorks Spa Repair Forum Tag: control panel en Sat, 20 Mar 2010 23:29:57 +0000 http://www.hottubworks.com/spa-repair-forum/topic/image-paradise-hydrothearpy-spa-control-panel#post-254 Wed, 09 Sep 2009 13:19:38 +0000 Mary 254@http://www.hottubworks.com/spa-repair-forum/ <p>This usually means that your sensors are out of balance. Since it is flashing between this error code and temperature it may be a temporary condition. If it does not go away I would start with the temperature sensor as the problem. </p> http://www.hottubworks.com/spa-repair-forum/topic/image-paradise-hydrothearpy-spa-control-panel#post-247 Mon, 07 Sep 2009 13:57:55 +0000 Anonymous 247@http://www.hottubworks.com/spa-repair-forum/ <p>does anyone know what the code "SnS" means on the image paradise hydrothearpy spa control panel, it is flashing between this code and the current water temp of the hot tub. </p> http://www.hottubworks.com/spa-repair-forum/topic/troubleshooting-button-clicks-but-jets-do-not-come-on#post-192 Wed, 05 Aug 2009 15:42:21 +0000 Anonymous 192@http://www.hottubworks.com/spa-repair-forum/ <p>Having a problem with an Infinity Spa. It has 3 pumps for 3 different "zones" connected to a Balboa M7 (53672-02 2M7P3) control pack and digital pad. When I press the "Jets 3" button there is a single audible click but nothing happens. The other 2 zones work fine. The spa heats and circulates without any other issues. </p> <p>I swapped the Jets 2 &#38; 3 plugs that go from the pumps to the control pack to confirm it was/was not a pump/motor problem. When switched Zone 3 (Jets 3 connected to Zone 2) works fine and Zone 2 (Jets 3 button connected to Zone 2) clicks with no result. Swapped back the result is consistent. All pumps and motors seem to be fine and the fuses inside the control pack test good with a continuity meter. </p> <p>How can I further run down the root problem? Does the click indicate anything specific? A relay problem, power, pad/button failure, circuit board, or something else? Thank you! </p>