Item #: 1-PW40E520
Our Price: $63.38
Availability: Usually leaves our warehouse within 1-2 business days
Waterway Executive 56-Frame, 4 horsepower, 2" Intake spa pumps use this wet end assembly, 310-1740. Suction and Discharge ports have 2" MBT threads, and outer threads measure 3" outside diameter to attach unions. Volute measures 7.75" wide X 8.5" tall.
Waterway Executive wet ends are also available in 1hp, 1.5hp, 2hp, 3hp Wet Ends for Waterway Executive pumps. Waterway 310-1740 Wet End assembly includes pre-assembled Volute, with 4 hp Impeller and shaft seal. Unions sold separately.
Replacing a Spa Pump Wet End: It is very simple to install a wet end, see Drake do it in under 1 minute in this spa pump wet end replacement video. Shut all power off. Then remove the bolts that connect the motor to the wet end. Now remove the small cover plate at the back of the motor, and place a large flat head screwdriver or wrench on the end of the motor shaft. Reach into the front of the wet end with your other hand to hold the impeller stationary, while you turn the screwdriver counter-clockwise, to un-thread the shaft from the impeller. Now, just pull the wet end off the front of the motor and replace with new, in reverse order.
Please Confirm you are not a bot
Thanks for the reply. I think I've found a new place for all my hot tub needs with hottubworks. I refuse to buy chemicals from my local hot tub dealer as their customer service is terrible. I regret doing business...read more