Free Shipping on all Spa Covers and orders over $100 Weekly Specials - 10% Off Covers PLUS 20% Off Parts!
1-800-770-0292
M-F - 7am-7pm CST
Sat. - 7am-4pm CST
Sun. - Closed

Testing Spa or Hot Tub Heater Elements

March 3rd, 2011 by

Spa Heater Element testing

 

Good heaters elements between 4.0 and 5.5kw should have the following results:

* 9-12 ohms of resistance
* good continuity
* draw 15-25 amps at 240v

You test the element by using an Ohm meter, or any multi-meter will work also. Just place it on Ohms, at 1000, and place your test leads on each of the terminals (power to spa heater should be off). As mentioned above,  a measurement of 9-12 Ohms of resistance usually indicates a good element.

To test for voltage, use an Amp meter, and use your test leads to measure the amp draw for the element. Excessive amp draw indicates a bad element, and no amp draw indicates that no power is reaching the terminals.

Poor spa chemistry can harm your spa heater elements, as can operating without water flowing over the element (which the pressure switch is designed to protect against).

Tags: , , , ,

One Response to “Testing Spa or Hot Tub Heater Elements”

  1. plumbing says:

    While there are some brands that do carry a gas portable heater, you almost always will find them in electric. If this is not something you are looking for you may want to consider not going with a portable. However, the electric portable spa heater is the most popular and has many benefits to it.

Leave a Reply